Features

Design benefits

waterproof

Moderate rain. Laminated fabric 15,000 Schmerbers | 100% taped seams.

windproof

Windbreaker, high collar, adjustable hood with visor. Salt-resistant zip.

pockets

4 pockets: 2 zipped fleece-lined, 1 zippped chest, 1 rip-tab inner

coverage

Hood (covering with visor and adjustable) can be stored in the collar.

Design details

Features of the 300 women's jacket

Compared with our 100 jacket, the 300 jacket: - a more waterproof component (15,000 Schmerbers) - rip-tab wrist fastenings - a hood that can be packed away into the collar and its depth can be adjusted - a yellow hood (on the grey jacket) for added visibility - an extra outer chest pocket Details below

Technical features of the component

Laminated fabric. Waterproof fabric: 15,000 Schmerbers - Water-repellent fabric (water runs off the fabric) - 100% taped seams, so that water does not leak through the seams

Collar and hood

The hood can be stored in the collar. The collar is then fastened with plastic press studs to prevent oxidation by salt. Depth and height-adjustable hood: adjustable at the back of hood and on the collar. The chin-high neck effectively protects the lower part of the face. 9 cm high collar (at the back)

Sleeve cuffs

The end of the sleeve is adjustable with a rip-tab. It lets you adjust the sleeve to your arm length, but also stops air and water coming in. To remove the jacket more easily, fully open the rip-tab.

Front zip closure

Using a zip on the entire jacket length with an interior channel (flap) that protects against the wind and water. Soft fabric flap on the top of the collar to protect the chin.

pockets

2 pockets on the front of the jacket, for your VHF, sail tie, cap, etc. Injection-moulded plastic zip to prevent salt oxidation 1 inside chest pocket on the left side to store your phone or other items, fastened with a zip 1 inside chest pocket on the right side fastened by a rip-tab PLEASE NOTE: the pockets are NOT WATERPROOF

Waterproofing - the component of the 300 jacket

We measure a fabric's resistance to water pressure in mm of water column (JIS standard). The higher the water pressure withstood by the fabric, the more waterproof it is. Here are the waterproofing ratings: Component resistant to water pressure of 5,000 mm after ageing (5 washes). This equates to 15,000 Schmerber (JIS standard), which is the average water pressure during a rain shower. The anorak's waterproofness was tested in a rain shower with 60 litres of water/m²/hour for 2 hours.

Component Breathability

To find out whether a fabric is breathable, we test its evaporate resistance or RET (ISO 11092 standard). The lower the fabric's resistance, the more moisture is evaporated, and therefore the higher the fabric's breathability. We consider that if: RET < 9 = very breathable fabric 9 < RET < 12 = breathable fabric. The Sailing 300 jacket's RET is < 9.

Water-repellent properties information

A fabric is water-repellent when water slides off the surface of the fabric, without seeping in. Your jacket does not become waterlogged and remains lightweight and breathable. The water-repellent properties are achieved with a treatment applied to the external side of the fabric, but in practice these properties can be altered. The water-repellent properties can be reactivated by putting the jacket in a dryer for 10 minutes at the lowest temperature.

How to wash your jacket?

To maintain the water repellent properties, infrequent washing is recommended. Close all the zips and flaps, empty the pockets and stow the hood in the collar. You can wash it on a synthetic cycle at 30°C or 40°C with your usual detergent. Do not use a conditioner, which may reduce the initial performance of the garment. Very important: choose a full rinse cycle or extra rinse.

How to reactivate the jacket's water repellency

Drying is a crucial phase in reactivating the water repellent treatment. We recommend that you lay your jacket flat on a clothes rack and leave it out to dry in the open. Caution: never dry your jacket directly on a radiator. Then place them in the tumble dryer on a short synthetics cycle, i.e. 10 to 15 minutes, before turning it back the right way round. Caution: do not over-dry the garment.

frequency	occasional
rain	moderate rain
fit	loose
neck type	zip neck
type of opening/closing	zip
number of pockets	3 pockets
reversible	not reversible
silent	not silent
zip type	full zip
type of lining	light/no lining
snow skirt	without snow skirt
waterproof	waterproof, water repellent
hood	with hood
pocket	inside pocket, zip closed pocket, with pocket
breathability	breathable
style	plain
ventilation system	without ventilation
mm H2O (Schmerbers)	15,000 mm
main material	polyamide
type of length	at the hips
condition	new
water-repellent	water repellent
windproof	windproof
lining material	synthetic
reinforced area	without reinforced area
sleeves length	long sleeves
modular	not modular
stitching type	with seam
reflective	without reflective zones
type of waterproofing	coating
thumb pass	without thumb pass
type of hood	adjustable hood, foldable hood, hood with visor
waterproof seam	with waterproof seam
breathability (in RET)	RET 6 < RET < 12 : moderately breathable
top length	long
storage	without storage

frequency	occasional
rain	moderate rain
fit	loose
neck type	zip neck
type of opening/closing	zip
number of pockets	3 pockets
reversible	not reversible
silent	not silent
zip type	full zip
type of lining	light/no lining
snow skirt	without snow skirt
waterproof	waterproof, water repellent
hood	with hood
pocket	inside pocket, zip closed pocket, with pocket
breathability	breathable
style	plain
ventilation system	without ventilation
mm H2O (Schmerbers)	15,000 mm
main material	polyamide
type of length	at the hips
condition	new
water-repellent	water repellent
windproof	windproof
lining material	synthetic
reinforced area	without reinforced area
sleeves length	long sleeves
modular	not modular
stitching type	with seam
reflective	without reflective zones
type of waterproofing	coating
thumb pass	without thumb pass
type of hood	adjustable hood, foldable hood, hood with visor
waterproof seam	with waterproof seam
breathability (in RET)	RET 6 < RET < 12 : moderately breathable
top length	long
storage	without storage

Raw material	86.023%
Manufacturing	3.209%
Packaging	0.04%
Distribution	5.212%
Use	3.847%
End of life	1.668%

frequency	occasional
rain	moderate rain
fit	loose
neck type	zip neck
type of opening/closing	zip
number of pockets	3 pockets
reversible	not reversible
silent	not silent
zip type	full zip
type of lining	light/no lining
snow skirt	without snow skirt
waterproof	waterproof, water repellent
hood	with hood
pocket	inside pocket, zip closed pocket, with pocket
breathability	breathable
style	plain
ventilation system	without ventilation
mm H2O (Schmerbers)	15,000 mm
main material	polyamide
type of length	at the hips
condition	new
water-repellent	water repellent
windproof	windproof
lining material	synthetic
reinforced area	without reinforced area
sleeves length	long sleeves
modular	not modular
stitching type	with seam
reflective	without reflective zones
type of waterproofing	coating
thumb pass	without thumb pass
type of hood	adjustable hood, foldable hood, hood with visor
waterproof seam	with waterproof seam
breathability (in RET)	RET 6 < RET < 12 : moderately breathable
top length	long
storage	without storage

Women's sailing waterproof windproof jacket SAILING 300 - Navy Blue

Features

Design benefits

Design details

Specifications

Details

Composition

Specifications

Details

Composition

Usage & care

Care instructions

Cleaning

Environmental impact

Carbon footprint

Ecodesign approach

Specifications

Details

Composition